半岛bd体育手机客户端 说明
一般描述
For solvents heavier than water: chloroform, dichloromethane, and others
Continuous extraction is achieved when fresh solvent dripping (refluxing) from condenserBtravels through the aqueous phase (upper layer) in extractorG. As the solvent collects at the bottom of the extractor and reaches the level of tubeE, it is siphoned automatically through the open PTFE stopcockDinto a heated solvent reservoir attached atC.
Procedure:
With PTFE stopcockDclosed, transfer a volume of solvent to the extractor to about the level of the stopcock. Carefully add the aqueous material making sure it does not run out the sidearm. Clamp the extractor onto a rack and attach a suitable flask half-full of solvent atC. The flask should be equipped with boiling chips or a magnetic stirring bar and a source of heat. Open stopcockDand slowly add solvent to the extractor until excess runs over to the flasks via return tubeE. Attach a reflux condenser atBand apply heat to the flasks so that rapid reflux is obtained.
For solvents lighter than water: hexanes, ether, ethyl acetate, and others
The diffusion tube adapterAis necessary when extracting with solvents lighter than water. Fresh solvent drips from the condenser into the adapter tube from which solvent diffuses at the bottom of the extractor; then the solvent rises through the aqueous layer because of its lower density. The extraction solvent is recycled to the solvent reservoir via sidearmF.
Procedure:
PTFE stopcockDshould be kept closed throughout the extraction procedure. Transfer the aqueous solution into the extractor (being careful not to let it run out the sidearm) and add the organic solvent slowly until the level in the extractor is approximately 1.5 inches below the sidearm. Carefully place diffusion tube adapterAinto the extractor, and attach a condenser atBand a flask about 65% full of solvent (and equipped with boiling chips or a magnetic stirring bar) atC. Apply heat to the flask so that rapid reflux is obtained.
Aldrich convertible liquid-liquid continuous extractor
Complete item includes extractor body and diffusion tube adapter (solvent flask (C), is not included and should be purchased separately).
法律信息
Aldrich is a registered trademark of sigma-aldrich Co. LLC
基本信息
NACRES | NB.43 |
半岛bd体育手机客户端 性质
接合处 | bottom Joint ST/NS24/40 top Joint ST/NS24/40 |
包装 | pack of 1 ea |
容量 | 250 mL |
Sigma-Aldrich